![]() The square hole will be done with either nibblers or a file.Ĭomplete Wii portable in an Altoids tin. The tin itself is malleable, so a 3d printed or wooden block will be inserted below to prevent the tin from bending while being drilled. All the holes other than the screen are round, and can then be drilled using a drill press. The decal will then be stuck to the tin to have a way to perfectly line up the holes. This will then be cut on a vinyl cutter to make a decal template. The components' outlines will be removed, and left with only the vectors of the holes. I have measured all of the components with calipers and fit them into a vector of their exact placements. The whole face is packed tightly, so there is literally no room for error. Although not too comfortable, most space effective way for the extra buttons was to have L, Start, Volume Up, Volume Down, Z, and R in a row at the top. I spent a few hours trying several different layouts, but I think this is going to be the final one. The first thing that will need to be accomplished is the face. 3DS sliders, GC+, all buttons are tact switches 35mm blower fan if I can fit it, passive cooling using the tin if I can't Mono audio from an older version of RDC's smAllMP Tiny LiPo cells with high C ratings from batteryspace for like 15 mins of battery life. Some stupid custom board trim with full NAND relocation They kept sending defective screens and it took weeks and a ton emails/tweets to actually get a response from their customer service. 2" 320x240 composite screen from AdaFruit (Dont buy it from adafruit. It will not be painted, and will look like an Altoids tin. Ive spent quite a bit of time on the layout and I have figured out how to make it work. I don't think its ever going to be possible to go smaller than this. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |